Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Current »

Step-by-step guide

  1. Launch the MagSwipe Configuration Software with the known working reader connected to a USB port of the computer directly
  2. Click the "Change Advanced Reader Settings" on the left (step #1) and then follow the numbered sequence in the screenshot below to get the working reader's settings read into this software
  3. You should see this confirmation pops  up:  
  4. Click the OK button. Disconnect the working reader first and then connect the new reader to the USB port 
  5. Click on the Clone to MSR button (step # 6) shown in the screenshot below:
  6. You should see this confirmation pops up:


Test read a card in Notepad to confirm the output looks exactly the same as the working reader's. And then do a transaction in your app to confirm it works.


This works with all the IDTECH USB/HID, USBKB & RS232 interface card readers that this Configuration software supports. (e.g. SecureMag, Easy Mag, SecureHead, etc.)

There is no content with the specified labels

  • No labels